Site Information

 Loading... Please wait...
  • SAE 30 running in oil for classic engines. Highest quality solvent refined mineral base stocks treated with specially designed additive system.

Classic SAE 30 Break-In Oil

$37.95
SKU:
C5439-5L
Quantity:

Product Description

• SAE 30 break in oil
• For break-in on the road, or dyno
• Change after approximately 500 miles

Application
Use for initial running in of re-built engines. Formulated for running in on the road. Can be used for test bed running. Run engine at peak torque to ensure maximum bedding-in of piston rings. Drain and refill with the Millers Classic lubricant most suitable for the engine. Suitable for limited road use (500 miles) after which it should be replaced with the appropriate Millers Classic Engine Oil.

User Benefits
• High quality mineral oil formulated to solve the problems experienced when reconditioned engines do not bed-in.
• Provides full protection to highly stressed valve gear and associated components whilst allowing piston rings to bed in against the bore.
• Good running in will optimise the performance and fuel efficiency of a reconditioned engine.
• Very low leak down (4%) obtained after thorough running in process.

Performance Profile
API: SE, CC

Typical Characteristics
SAE Viscosity 30
Specific Gravity (at 15°C) 0.887
Kinematic Viscosity (at 100°C, cSt) 11.9
Kinematic Viscosity (at 40°C, cSt) 104
Viscosity Index 103
Pour Point (°C) -15
Flash Point (°C) >200
Heath & Safety Health and Safety Data Sheet 5439 applies to this product. When used for the purpose recommended and with due regard to the appropriate Health and Safety Data, the product should cause no concern. If in doubt, consult with Performance Racing Oils. For Technical assistance call Performance Racing Oils at 865-200-4264.

Product Reviews

Write Review

This product hasn't received any reviews yet. Be the first to review this product!

Find Similar Products by Category

Click the button below to add the Classic SAE 30 Break-In Oil to your wish list.